enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   12V only power connector (labelled P1, though it is not compatible with the ATX 20 or 24 pin connector): This is a 10 or 16-pin Molex connector supplying the motherboard with three or six 12 V lines with common returns, a 'supply OK' signal, a 'PSU ON' signal and a 12 or 11 V auxiliary supply. One pin is left unused.

3. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...

4. PS-ON Signal - Wikipedia

   en.wikipedia.org/wiki/PS-ON_Signal

   PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...

5. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   The most notable difference from modern 20/24-pin ATX power connectors is that the AT power supply connector did not have a signal to turn on the power supply, and also did not supply separate, "always-on" +5V standby power. The power supply was instead turned on and off via a mechanical switch that disconnected mains power. Modern, ATX ...

6. Mini-ITX - Wikipedia

   en.wikipedia.org/wiki/Mini-ITX

   The Mini-ITX standard does not define a standard for the computer power supply, though it suggests possible options. Conventionally Mini-ITX boards use a 20- or 24-pin "original ATX" power connector. This is usually connected to a DC-DC converter board, which connects to an external power adapter.

7. Power good signal - Wikipedia

   en.wikipedia.org/wiki/Power_good_signal

   The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.