Search results
Results from the WOW.Com Content Network
A better estimate is provided by the total area of the cross-sections perpendicular to the muscle fibers (green lines in figure 1). This measure is known as the physiological cross-sectional area (PCSA), and is commonly calculated and defined by the following formula, developed in 1975 by Alexander and Vernon: [4] [5] [6]
during contraction, actin filaments move into the A bands and the H zone is filled up reducing its stretch, the I bands shorten, the Z line comes in contact with the A bands; and; the possible driving force of contraction is the actin-myosin linkages which depend on ATP hydrolysis by the myosin.
Isotonic contractions differ from isokinetic contractions in that in isokinetic contractions the muscle speed remains constant. While superficially identical, as the muscle's force changes via the length-tension relationship during a contraction, an isotonic contraction will keep force constant while velocity changes, but an isokinetic ...
The angle of pennation will increase during contraction accompanied by an increase in thickness. Thickness is defined as the area between the aponeuroses of the muscle. A low gear ratio occurs when the contraction velocity of the whole muscle and individual fibers is approximately the same, resulting in a gear ratio of 1.
This 'low' level of contraction is a protective mechanism to prevent avulsion of the tendon—the force generated by a 95% contraction of all fibers is sufficient to damage the body. In multiple fiber summation , if the central nervous system sends a weak signal to contract a muscle, the smaller motor units , being more excitable than the ...
When a sarcomere contracts, the Z lines move closer together, and the I band becomes smaller. The A band stays the same width. At full contraction, the thin and thick filaments overlap. Contraction in more detail. Contraction is achieved by the muscle's structural unit, the muscle fiber, and by its functional unit, the motor unit. [4]
The origin of a muscle is the bone, typically proximal, which has greater mass and is more stable during a contraction than a muscle's insertion. [14] For example, with the latissimus dorsi muscle, the origin site is the torso, and the insertion is the arm. When this muscle contracts, normally the arm moves due to having less mass than the torso.
Therefore, the higher the load applied to the muscle, the lower the contraction velocity. Similarly, the higher the contraction velocity, the lower the tension in the muscle. This hyperbolic form has been found to fit the empirical constant only during isotonic contractions near resting length. [1]