Search results
Results from the WOW.Com Content Network
A Wheatstone bridge is an electrical circuit used to measure an unknown electrical resistance by balancing two legs of a bridge circuit, one leg of which includes the unknown component. The primary benefit of the circuit is its ability to provide extremely accurate measurements (in contrast with something like a simple voltage divider ). [ 1 ]
The two remaining arms are the nearly equal resistances P and Q, connected in the inner gaps of the bridge. A standard Wheatstone bridge for comparison. Points A, B, C and D in both circuit diagrams correspond. X and Y correspond to R 1 and R 2, P and Q correspond to R 3 and R X. Note that with the Carey Foster bridge, we are measuring R 1 ...
The best-known bridge circuit, the Wheatstone bridge, was invented by Samuel Hunter Christie and popularized by Charles Wheatstone, and is used for measuring resistance. It is constructed from four resistors, two of known values R 1 and R 3 (see diagram), one whose resistance is to be determined R x , and one which is variable and calibrated R 2 .
A Maxwell-Wien bridge. A Maxwell bridge is a modification to a Wheatstone bridge used to measure an unknown inductance (usually of low Q value) in terms of calibrated resistance and inductance or resistance and capacitance. [1] When the calibrated components are a parallel resistor and capacitor, the bridge is known as a Maxwell bridge.
The first rendering in figure 1.8 is the traditional depiction of a bridge circuit. The second rendering clearly shows the equivalence between the bridge topology and a topology derived by series and parallel combinations. The third rendering is more commonly known as lattice topology. It is not so obvious that this is topologically equivalent.
The operation of the Kelvin bridge is very similar to the Wheatstone bridge, but uses two additional resistors. Resistors R 1 and R 2 are connected to the outside potential terminals of the four terminal known or standard resistor R s and the unknown resistor R x (identified as P 1 and P′ 1 in the diagram).
In extreme conditions, he orders extra weather advice from Ponant HQ, but if you’re imagining the staff on the bridge desperately radioing for advice as waves batter the ship, think again.
The lattice structure can be converted to an unbalanced form (see below), for insertion in circuits with a ground plane. Such conversions also reduce the component count and relax component tolerances. [6] It is possible to redraw the lattice in the Wheatstone bridge configuration [7] (as shown in the article Zobel network). However, this is ...