enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Come-along - Wikipedia

   en.wikipedia.org/wiki/Come-along

   A come-along. A come-along, also known as a power puller, is a hand-operated winch with a ratchet used to pull objects. The drum is wrapped with wire rope.A similar tool that uses a nylon strap is used to straighten trees, as it straightens gradually over time, therefore not splitting the trunk.

3. Puller - Wikipedia

   en.wikipedia.org/wiki/Puller

   Richard Puller (1747–1826), English merchant banker; Sir Christopher Puller (1774 – 26 May 1824), English lawyer; briefly Chief Justice of Bengal; son of Richard; Chesty Puller, a United States Marine Corps officer during World War II and the Korean War, and the most decorated Marine in the history of the Corps

4. Mechanical advantage device - Wikipedia

   en.wikipedia.org/wiki/Mechanical_advantage_device

   Examples of rope and pulley systems illustrating mechanical advantage. Consider lifting a weight with rope and pulleys. A rope looped through a pulley attached to a fixed spot, e.g. a barn roof rafter, and attached to the weight is called a single pulley. It has a mechanical advantage (MA) = 1 (assuming frictionless bearings in the pulley ...

5. Harmonic damper - Wikipedia

   en.wikipedia.org/wiki/Harmonic_damper

   Harmonic balancer lower pulley on a four-cylinder engine. A harmonic damper is a device fitted to the free (accessory drive) end of the crankshaft of an internal combustion engine to counter torsional and resonance vibrations from the crankshaft. This device must be an interference fit to the crankshaft in order to operate in an effective ...

6. Pulley - Wikipedia

   en.wikipedia.org/wiki/Pulley

   A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force. A pulley may have a groove or grooves between flanges around its circumference to locate the cable or belt. The drive element of a pulley system can be a rope, cable, belt, or chain.

7. Broaching (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Broaching_(metalworking)

   Broaching is a machining process that uses a toothed tool, called a broach, to remove material.There are two main types of broaching: linear and rotary.In linear broaching, which is the more common process, the broach is run linearly against a surface of the workpiece to produce the cut.