enow.com Web Search

  1. Ads

    related to: heater hose size chart

Search results

  1. Results from the WOW.Com Content Network
  2. Heated hose - Wikipedia

    en.wikipedia.org/wiki/Heated_hose

    Heated hoses are suitable for environments from -40°C to 80°C and can be used in explosion-proof zones 1/21 and 2/22, if required. [3] A heated hose consists of a flexible hose, through which the media is pumped. This hose determines the resistance against temperature and chemicals.

  3. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...

  4. Induction shrink fitting - Wikipedia

    en.wikipedia.org/wiki/Induction_shrink_fitting

    Induction heating is a non contact heating process which uses the principle of electromagnetism induction to produce heat in a work-piece. In this case thermal expansion is used in a mechanical application to fit parts over one another, e.g. a bushing can be fitted over a shaft by making its inner diameter slightly smaller than the diameter of the shaft, then heating it until it fits over the ...

  5. Copper tubing - Wikipedia

    en.wikipedia.org/wiki/Copper_tubing

    Copper pipes in Australia are referenced to their DN (diamètre nominal) number, which is a nominal millimeter equivalent to their actual Imperial size. For example, DN20 is the size for copper pipe with an outside diameter of 19.05 mm or 3 ⁄ 4 inch.

  6. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  7. Heating element - Wikipedia

    en.wikipedia.org/wiki/Heating_element

    An optimized heater design helps to control the heating power and modulate the local temperatures across the heater substrate. In cases where there is a requirement of two or more heating zones with different power densities over a relatively small area, a thick-film heater can be designed to achieve a zonal heating pattern on a single substrate.

  1. Ads

    related to: heater hose size chart