Search results
Results from the WOW.Com Content Network
The particular take-off distance required may be shorter than the available runway length. In this case a lower thrust may be used. Lower thrust settings increase engine life and reduce maintenance costs. The take-off thrust available from a civil engine is a constant value up to a particular ambient temperature.
When the energy is available, arcjets are well suited to keeping stations in orbit and can replace monopropellant rockets. Aerojet MR-510 series arcjet engines are currently used on Lockheed Martin A2100 satellites using hydrazine as a propellant, [ 3 ] providing over 585 s average specific impulse at 2 kW .
The required take-off thrust was 14,500 lb which would normally be set by advancing the thrust levers to give an EPR reading of 2.04. Due to EPR probe icing the value set, i.e. 2.04, was erroneous and actually equivalent to 1.70 which gave an actual thrust of only 10,750 lb.
Aircraft engine performance refers to factors including thrust or shaft power for fuel consumed, weight, cost, outside dimensions and life. It includes meeting regulated environmental limits which apply to emissions of noise and chemical pollutants, and regulated safety aspects which require a design that can safely tolerate environmental hazards such as birds, rain, hail and icing conditions.
The thrust efficiency is the actual thrust as percentage of this. If, e.g., solar power is used, this restricts a {\displaystyle a} ; in the case of a large v e {\displaystyle v_{\text{e}}} the possible acceleration is inversely proportional to it, hence the time to reach a required delta-v is proportional to v e {\displaystyle v_{\text{e ...
Whereas, if an engine fails just below a high V 1, it will take more distance to stop, so the Accelerate Stop Distance Required is greater. [8] Alternatively, on runways longer than the balanced field length the pilot can use reduced thrust, resulting in the balanced field length again being equal to the runway length available. [citation needed]
If a powered aircraft is generating thrust T and experiencing drag D, the difference between the two, T − D, is termed the excess thrust. The instantaneous performance of the aircraft is mostly dependent on the excess thrust. Excess thrust is a vector and is determined as the vector difference between the thrust vector and the drag vector.
Specific thrust is the thrust per unit air mass flowrate of a jet engine (e.g. turbojet, turbofan, etc.) and can be calculated by the ratio of net thrust/total intake airflow. [ 1 ] Low specific thrust engines tend to be more efficient of propellant (at subsonic speeds), but also have a lower effective exhaust velocity and lower maximum airspeed.