Search results
Results from the WOW.Com Content Network
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
Cable 2/50 S (2.2 mm outer / 1 mm inner diameter) SSMB-Nano. The SSMB-Nano connector is a small version of the standard SMB connector with a 'snap-on' coupling.
XLR3 cable connectors female (left) and male. The XLR connector is a type of electrical connector primarily used in professional audio, video, and stage lighting equipment. XLR connectors are cylindrical, with three to seven connector pins, and are often employed for analog balanced audio interconnections, AES3 digital audio, portable intercom, DMX512 lighting control, and for low-voltage ...
The cable and satellite television entities (as a near standard practice) use compression fittings with F connectors on customer premises. In Europe, block down-converted satellite signals (950–2150 MHz) from LNBs and DC power and block signalling from satellite receivers are near exclusively passed through F connectors.
For similar reasons, "wye"-cables (or "Y-splitters") should not be used to combine two line out signals into a single line in. Each line output would be driving the other line output as well as the intended input, again resulting in a much heavier load than designed for. This will result in signal loss and possibly even damage.
The USB Type-C Cable and Connector Specification specifies a mapping from a USB-C jack to a 4-pole TRRS jack, for the use of headsets, and supports both CTIA and OMTP (YD/T 1885–2009) modes. [78] Some devices transparently handle many jack standards, [79] [80] and there are hardware implementations of this available as components. [81]
The search engine that helps you find exactly what you're looking for. Find the most relevant information, video, images, and answers from all across the Web.
Cables should meet the S/PDIF specification as defined by the international standard IEC 60958-3 for assured performance. The male plug has a center pin that is 1 ⁄ 8 inch (3.175 mm) in diameter, and is surrounded by an outer shell that is 1 ⁄ 3 inch (8.47 mm) in diameter.