Search results
Results from the WOW.Com Content Network
Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.
All sawmills use ripsaws of various types including the circular saw and band saw. Historically sawmills used one or more reciprocating saws more specifically known as an "up-and-down" or "upright saw" which are of two basic types, the frame saw or a muley (mulay) saw [ 2 ] which is similar to the hand powered pit saw .
Rip cuts are commonly made with a table saw, but other types of power saws can also be used, including a radial arm saw, band saw, and hand held circular saw.In sawmills the head saw is the first rip-saw a log goes through, which is sometimes a gang-saw, and then the cants may be resawn using other saws and then edged in an edger and sometimes cut to length by a crosscut saw.
The two applications require slightly different designs: a felling saw has a narrower blade, allowing wedges to be more easily inserted, while a bucking saw has a wider blade, giving it more strength. Two-man saws were designed to cut in both directions. Careful tooth design was necessary to clear the sawdust during the cut.
Saw blade "grabbing" occurs more frequently during ripping than cross-cutting (cuts made to wood or stone across its main grain or axis). It can occur with both hand saws and bandsaws but is more dangerous with a circular saw as areas of the circular blade close to the cutting area are moving in different directions. If a bandsaw grabs, the ...
The cutting edge of each tooth is angled in an alternating pattern. This design allows each tooth to act like a knife edge and slice through the wood in contrast to a rip saw, which tears along the grain, acting like a miniature chisel. Some crosscut saws use special teeth, called rakers, designed to clean out the cut strips of wood from the ...
A saw which combines the sliding and compound features is known as a sliding compound miter saw or SCMS. Before the advent of the radial arm saw, table saws and hand saws were most commonly used for crosscutting lumber. Table saws can easily rip stock, but it is awkward to push a long piece of stock widthwise through a table saw blade.
Rotary saw or "spiral-cut saw" or "RotoZip": for making accurate cuts, without using a pilot hole, in wallboard, plywood, and other thin materials. Electric miter saw or "chop saw," or "cut-off saw" or "power miter box": for making accurate cross cuts and miter cuts. The basic version has a circular blade fixed at a 90° angle to the vertical.