Search results
Results from the WOW.Com Content Network
Carbonate hardness, is a measure of the water hardness caused by the presence of carbonate (CO 2− 3) and bicarbonate (HCO − 3) anions. Carbonate hardness is usually expressed either in degrees KH (from the German "Karbonathärte"), or in parts per million calcium carbonate ( ppm CaCO 3 or grams CaCO 3 per litre|mg/L).
Mohs hardness of materials (data page) Vickers hardness test; Brinell scale This page was last edited on ...
Carbonate hardness is a measure of the concentration of carbonates such as calcium carbonate (CaCO 3) and magnesium carbonate (MgCO 3) per volume of water. As a unit 1 dKH is the same as 1 °dH which is equal to approximately 0.1786 mmol/L or 17.86 milligrams (mg) of calcium carbonate per litre of water, i.e. 17.86 ppm.
Water containing these minerals is known as "hard water". [citation needed] When hard water is heated in a plumbing system, carbon dioxide goes out of solution, and bicarbonates become carbonates, which are much less soluble. The carbonates bind to plumbing surfaces providing seed crystals for further crystal growth, which build up as hard scale.
A bathtub faucet with built-up calcification from hard water in Southern Arizona. Hard water is water that has a high mineral content (in contrast with "soft water"). Hard water is formed when water percolates through deposits of limestone, chalk or gypsum, [1] which are largely made up of calcium and magnesium carbonates, bicarbonates and sulfates.
In water testing hardness is often measured in parts per million (ppm), where one part per million is defined as one milligram of calcium carbonate (CaCO 3) per litre of water. Consequently, 1 dGH corresponds to 10 ppm CaO but 17.848 ppm CaCO 3 which has a molar mass of 100.09 g/mol.
Find out how age and weight go together, here. Plus, expert tips for losing weight after 50, including diet plans, calorie needs, and low-impact workouts.
When testing coatings, scratch hardness refers to the force necessary to cut through the film to the substrate. The most common test is Mohs scale, which is used in mineralogy. One tool to make this measurement is the sclerometer. Another tool used to make these tests is the pocket hardness tester. This tool consists of a scale arm with ...