Search results
Results from the WOW.Com Content Network
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead. Hardware interrupts are used to handle events such as receiving data from a modem or network card , key presses, or mouse movements.
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.
The Intel 8253 PIT was the original timing device used on IBM PC compatibles.It used a 1.193182 MHz clock signal (one third of the color burst frequency used by NTSC, one twelfth of the system clock crystal oscillator, [1] therefore one quarter of the 4.77 MHz CPU clock) and contains three timers.
An interrupt is scheduled to allow the operating system kernel to switch between processes when their time slices expire, effectively allowing the processor's time to be shared among a number of tasks, giving the illusion that it is dealing with these tasks in parallel (simultaneously). The operating system which controls such a design is ...
INT is an assembly language instruction for x86 processors that generates a software interrupt. It takes the interrupt number formatted as a byte value. [1] When written in assembly language, the instruction is written like this: INT X. where X is the software interrupt that should be generated (0-255).
The SIGINT signal is sent to a process by its controlling terminal when a user wishes to interrupt the process. This is typically initiated by pressing Ctrl+C, but on some systems, the "delete" character or "break" key can be used. [13] SIGKILL The SIGKILL signal is sent to a process to cause it to terminate immediately (kill). In contrast to ...