Search results
Results from the WOW.Com Content Network
The drawback is that once the radar is set to tracking a single target, the operator loses information about any other targets. This is the problem that track while scan is meant to address. In traditional radar systems, the display is purely electrical; signals from the radar dish are amplified and sent directly to an oscilloscope for display ...
In radar technology and similar fields, track-before-detect (TBD) is a concept according to which a signal is tracked before declaring it a target. In this approach, the sensor data about a tentative target are integrated over time and may yield detection in cases when signals from any particular time instance are too weak against clutter (low signal-to-noise ratio) to register a detected target.
The AN/AWG-9 and AN/APG-71 radars are all-weather, multi-mode X band pulse-Doppler radar systems used in the F-14 Tomcat, and also tested on TA-3B. [1] It is a long-range air-to-air system capable of guiding several AIM-54 Phoenix or AIM-120 AMRAAM missiles simultaneously, using its track while scan mode.
Sensors information (radar, sonar, and transponder data) is provided to the track algorithm using a polar coordinate system, and this is converted to cartesian coordinate system for the track algorithm. The polar to Cartesian conversion uses navigation data for sensors mounted on vehicles, which eliminates sensor position changes caused by ship ...
In scanning mode, the radar can scan around a specified sector looking for any moving objects. It is also capable of "Track-while-Scan" (TWS) operation, and can track 50 targets in TWS acquisition mode. The speed of scan can also be adjusted by adjusting the speed of the antenna's rotation to either a low, medium or high rotational speed.
Each array scans a given azimuth sector, providing a total coverage of 360°. Scanning is carried out electronically in both azimuth and elevation. Radar modes include high PRF search and full track, track-while-scan, a slow scan detection mode for hovering and low-speed helicopters (using rotor blade returns) and a low PRF ship detection mode. [1]
Pulse-Doppler radar sensors are therefore more suited for long-range detection, while FMCW radar sensors are more suited for short-range detection. Monopulse : A monopulse feed network, as shown in Fig. 2, increases the angular accuracy to a fraction of the beamwidth by comparing echoes, which originate from a single radiated pulse and which ...
The radar can reportedly manage up to 40 targets, monitor up to 10 of them in track-while-scan (TWS) mode and simultaneously fire on two BVR targets. [3] The detection range for targets with a radar cross-section of 3 square meters is stated to be ≥75 km (≥35 km in look-down mode).