enow.com Web Search

  1. Ads

    related to: how to make silicone rubber molds

Search results

  1. Results from the WOW.Com Content Network
  2. Injection molding of liquid silicone rubber - Wikipedia

    en.wikipedia.org/wiki/Injection_molding_of...

    Injection molding of liquid silicone rubber (LSR) is a process to produce pliable, durable parts in high volume.. Liquid silicone rubber is a high purity platinum cured silicone with low compression set, good stability and ability to resist extreme temperatures of heat and cold ideally suitable for production of parts, where high quality is required.

  3. Spin casting - Wikipedia

    en.wikipedia.org/wiki/Spin_casting

    The spin casting process typically uses vulcanized silicone or organic rubber as the mold-making substrate. Vulcanization is an integral step that occurs halfway through the mold-making process. Prior to vulcanization, the mold rubber is a soft and malleable solid-like fluid, in many ways very similar to Silly Putty. Because of the clay-like ...

  4. Silicone - Wikipedia

    en.wikipedia.org/wiki/Silicone

    Two-part silicone systems are used as rubber molds to cast resins, foams, rubber, and low-temperature alloys. A silicone mold generally requires little or no mold-release or surface preparation, as most materials do not adhere to silicone. For experimental uses, ordinary one-part silicone can be used to make molds or to mold into shapes.

  5. Vacuum casting (elastomers) - Wikipedia

    en.wikipedia.org/wiki/Vacuum_casting_(elastomers)

    The process starts by placing a two piece silicone mold in a vacuum chamber. The raw material is mixed, degassed and then poured into the mold. The vacuum is then released and the mold removed from the chamber. Finally, the casting is cured in an oven and the mold removed to release the completed casting. The silicone mold can be reused. [3]

  6. Compression molding - Wikipedia

    en.wikipedia.org/wiki/Compression_molding

    Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...

  7. How to Make a Jell-O Mold That Comes Out Perfect

    www.aol.com/jell-o-mold-comes-perfect-150003594.html

    Use hot water to remove a stubborn Jell-O mold: If your mold isn’t releasing from the pan, set the mold in a pan of hot water for 10 seconds and try to remove it again. Repeat the process until ...

  1. Ads

    related to: how to make silicone rubber molds