Search results
Results from the WOW.Com Content Network
The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5] USB 3.0 connectors are generally backward compatible, but include new wiring and full-duplex operation.
The USB-C plug USB cable with a USB-C plug and a USB-C port on a notebook computer. The USB-C connector supersedes all earlier USB connectors and the Mini DisplayPort connector. It is used for all USB protocols and for Thunderbolt (3 and later), DisplayPort (1.2 and later), and others.
The USB 3.x family has had the same technical notation retroactively added in the USB 3.1 and USB 3.2 specification versions. Though this shows common principles and the same generations refer to the same nominal speeds, "Gen A" does not have the same exact meaning in both USB 3.x and USB4 specifications.
The USB 3.1 specification takes over the existing USB 3.0's SuperSpeed USB transfer rate, now referred to as USB 3.1 Gen 1, and introduces a faster transfer rate called SuperSpeed USB 10 Gbps, corresponding to operation mode USB 3.1 Gen 2, [62] putting it on par with a single first-generation Thunderbolt channel.
The xHCI reduces the need for periodic device polling by allowing a USB 3.0 or later device to notify the host controller when it has data available to read, and moves the management of polling USB 2.0 and 1.1 devices that use interrupt transactions from the CPU-driven USB driver to the USB host controller.
This section describes the power distribution model of USB that existed before Power-Delivery (USB-PD). On devices that do not use PD, USB provides up to 7.5 W through Type-A and Type-B connectors, and up to 15 W through USB-C. All pre-PD USB power is provided at 5 V. For a host providing power to devices, USB has a concept of the unit load ...
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams
USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card , providing an interface for transmitting Ethernet or ATM frames onto some physical media.