Search results
Results from the WOW.Com Content Network
Smoothing groups are useful for describing shapes where some polygons are connected smoothly to their neighbors, and some are not. For example, in a mesh representing a cylinder, all of the polygons are smoothly connected except along the edges of the end caps. One could make a smoothing group containing all of the polygons in one end cap ...
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.
Float shifting can reduce clutch wear because it is used so much less (only for starting from a standstill). Conversely, improper engagement of a gear (when the engine and transmission speeds aren't matched) can cause wear on the synchros and lockouts, and damage the gears by physically grinding them together due to a difference in speed.
Preselector gearboxes were often marketed as "self-changing" gearboxes, [1] however this is an inaccurate description as the driver is required to choose the gear (and often manually actuate the gear change). An automatic transmission is a true "self-changing gearbox" since it is able to change gears without any driver involvement.
By its nature, a freewheel mechanism acts as an automatic clutch, making it possible to change gears in a manual gearbox, either up- or downshifting, without depressing the clutch pedal, limiting the use of the manual clutch to starting from standstill or stopping. The Saab freewheel can be engaged or disengaged by the driver by respectively ...
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
An automated manual transmission may include a fully automatic mode where the driver does not need to change gears at all. [24] These transmissions can be described as a standard manual transmission with an automated clutch and automated gear shift control, allowing them to operate in the same manner as traditional automatic transmissions.
A transmission (also called a gearbox) is a mechanical device which uses a gear set—two or more gears working together—to change the speed, direction of rotation, or torque multiplication/reduction in a machine. [1] [2] Transmissions can have a single fixed-gear ratio, multiple distinct gear ratios, or continuously variable ratios. Variable ...