Search results
Results from the WOW.Com Content Network
This engine uses a MAF sensor to monitor manifold pressure, similar to the G16B series. This engine has a non-interference valvetrain design. It uses the same G series block found in many other Suzuki models and so it is a popular conversion into the Suzuki Sierra/Samurai, which uses either a G13A (85-88) or G13BA (88.5-98).
Most modern engines with a "straight" (inline) layout today use a single cylinder head that serves all the cylinders. Engines with a "V" layout or "flat" layout typically use two cylinder heads (one for each cylinder bank), however a small number of 'narrow-angle' V engines (such as the Volkswagen VR5 and VR6 engines) use a single cylinder head ...
The LT1 uses a new engine block, cylinder head, timing cover, water pump, intake manifold and accessory brackets. The harmonic damper also does not interchange; it is a unique damper/pulley assembly. Engine mounts and bell housing bolt pattern remain the same, permitting a newer engine to be readily swapped into an older vehicle.
The cylinder head is tipped upwards for illustrative purposes. An engine where all the cylinders share a common block is called a monobloc engine. Most modern engines use a monobloc design, and few have a separate block for each cylinder. This has led to the term "engine block," which usually implies a monobloc design, with "monobloc" rarely used.
These engines were built exclusively at Bupyeong engine plant and marketed as E-TEC. Like all Family 1 engines they feature a toothed belt driven valvetrain, a cast-iron engine block and an aluminum cylinder head. Most models feature Euro III-compliancy, and the 1.4 L (1399 cc) and 1.6 L (1598cc) versions employ variable intake geometry.
A cylinder head of a four valve Nissan VQ engine engine. A multi-valve or multivalve engine is one where each cylinder has more than two valves (an intake, and an exhaust).A multi-valve engine has better breathing, and with more smaller valves (having less mass in motion) may be able to operate at higher revolutions per minute (RPM) than a two-valve engine, delivering more power.
A Heron cylinder head, or simply Heron head, is a design for the combustion chambers of the cylinder head on an internal combustion piston engine, named for engine designer S. D. Heron. The head is machined flat, with recesses only for inlet and exhaust valves, spark plugs, injectors and so on. The combustion chamber itself is contained within ...
This new engine was known as R92A and used for powering the 1965-1966 Daihatsu P3 and 1967 Daihatsu P5 race cars. The cylinder head was also modified from 8-valve OHV to 16-valve DOHC, an extremely rare configuration at that time. At first the power output was originally 110 PS (81 kW) which was then increased to 130 PS (96 kW) at 8000 rpm.