Search results
Results from the WOW.Com Content Network
The routing configuration and usage of an aux-send will vary depending on the application. Two types of aux-sends commonly exist: pre-fader and post-fader. Pre-fader sends are not affected by the main fader for the channel, while post-fader sends are affected by the position of the main fader slider control for the channel.
The auxiliary send routes a split of the incoming signal to an auxiliary bus, which can then be routed to external devices. Auxiliary sends can either be pre-fader or post-fader, in that the level of a pre-fader send is set by the auxiliary send control, whereas post-fade sends depend on the position of the channel fader as well.
If a send mix is configured post-fader, then the level sent to the send mix follows changes to the main channel strip fader. [22] This is useful for reverberation and other signal processor effects. An example of this is when an engineer would like to add some delay to the vocals – the fader can thus be used to adjust the amount of delay ...
Until the 3.0 revision, very low data rates meant most A/V needed alternative connectors. USB-C can directly transport USB 3.1, DisplayPort, Thunderbolt, HDMI, and MHL protocols, with power, and audio and many other protocols are possible. Thunderbolt is the successor to FireWire, a generic high-speed data link with well-defined audio/video ...
The send jack can always be counted on to send signal out to an external devices. A refinement of the normalization of jacks is the presence on the mixer of an insert control which, when adjusted, allows the user to patch into or around the inserted devices at will without having to physically disconnect the insert cables.
Rather than tie up the high-bandwidth USB bus sending data to a slower USB device, the nearest high-bandwidth capable hub receives a SPLIT token followed by one or two USB packets at high-bandwidth, performs the data transfer at full- or low-bandwidth, and provides the response at high-bandwidth when prompted by a second SPLIT token.
Starting in the 2000s, most IBM PC compatible computers removed their external RS-232 COM ports and used USB ports that can send data faster. For users who still need RS-232 serial ports, external USB-to-UART bridges are now commonly used. They combine the hardware cables and a chip to do the USB and UART conversion.
In audio engineering, a gain stage is a point during an audio signal flow that the engineer can make adjustments to the level, [1] such as a fader on a mixing console or in a DAW.