Search results
Results from the WOW.Com Content Network
If the value in the register is set to less than the actual hard drive size then effectively a host protected area is created. It is protected because the OS will work with only the value in the register that is returned by the IDENTIFY DEVICE command and thus will normally be unable to address the parts of the drive that lie within the HPA.
Hot swapping may be used to add or remove peripherals or components, to allow a device to synchronize data with a computer, and to replace faulty modules without interrupting equipment operation. A machine may have dual power supplies , each adequate to power the machine; a faulty one may be hot-swapped.
The Hewlett-Packard HP3013/3014, nicknamed Kittyhawk, was a hard disk drive introduced by Hewlett-Packard on June 9, 1992. [1] [2] At the time of its introduction, it was the smallest hard disk drive in the world, being only 1.3-inches in size. The drive was created by a collaboration between Hewlett-Packard, AT&T, and Citizen Watch. [3] [2]
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
The software then tells the hard disk drive to unload its heads to prevent them from coming in contact with the platters, thus potentially preventing a head crash. [1] Many laptop vendors have implemented this technology under different names. [2] Some hard-disk drives also include this technology, needing no cooperation from the system. [3]
This can be avoided by unplugging the appliance or using a power strip and using the switch on the power strip to cut all power to the appliance." [3] Standby power used by older devices can be as high as 10–15 W per device, [4] while a modern HD LCD television may use less than 1 W in standby mode. Some appliances use no energy when turned off.
DevSlp or DevSleep (sometimes referred to as device sleep or SATA DEVSLP) is a feature in some SATA devices which allows them to go into a low power "device sleep" mode when sent the appropriate signal, which uses one or two orders of magnitude less power than a traditional idle (about 5 mW, [1] but some drives can get as low as 2.5 mW [2]).
Power-on hours (POH) is the length of time, usually in hours, [1] that electrical power is applied to a device. A part of the S.M.A.R.T. attributes (originally known as IntelliSafe, before its introduction to the public domain on 12 May 1995, by the computer hardware and software company Compaq ), [ 2 ]