Search results
Results from the WOW.Com Content Network
The figures below are simplex data rates, ... 10/2.5 Gbit/s: 1.25/0.3125 GB/s: 2012 [18] DOCSIS 4.0 (cable modem) 10/6 Gbit/s: 1.25/0.75 ...
This allows a single cable to provide both power and data for high-bandwidth wireless access points such as those that implement the 802.11ac and 802.11ax standards. [ 8 ] Prior to the release of 2.5GBASE-T and 5GBASE-T, manufacturers of wireless access points that wanted to support multi-gigabit uplink speed using standard gigabit Ethernet ...
In order to calculate the data transmission rate, one must multiply the transfer rate by the information channel width. For example, a data bus eight-bytes wide (64 bits) by definition transfers eight bytes in each transfer operation; at a transfer rate of 1 GT/s, the data rate would be 8 × 10 9 B/s, i.e. 8 GB/s, or approximately 7.45 GiB/s
114 minutes of uncompressed CD-quality audio at 1.4 Mbit/s is approximately 1 GB. A single-layer DVD+R disc can hold about 4.7 GB. A dual-layered DVD+R disc can hold about 8.5 GB. A single-layer Blu-ray can hold about 25 GB. The largest Nintendo Switch cartridge available on the market holds about 32 GB. A dual-layered Blu-ray can hold about 50 GB.
The cable must be capable of transmitting 600 MHz for 1000BASE-T1 and 66 MHz for 100BASE-T1. 2.5 Gb/s, 5 Gb/s, and 10 Gb/s over a 15 m single pair is standardized in 802.3ch-2020. [25] In June 2023, 802.3cy added 25 Gb/s speeds at lengths up to 11 m. [26] Similar to PoE, Power over Data Lines (PoDL) can provide up to 50 W to a device. [27]
These prefixes are more often used for multiples of bytes, as in kilobyte (1 kB = 8000 bit), megabyte (1 MB = 8 000 000 bit), and gigabyte (1 GB = 8 000 000 000 bit). However, for technical reasons, the capacities of computer memories and some storage units are often multiples of some large power of two, such as 2 28 = 268 435 456 bytes.
The exponentiation inherent in floating-point computation assures a much larger dynamic range – the largest and smallest numbers that can be represented – which is especially important when processing data sets where some of the data may have extremely large range of numerical values or where the range may be unpredictable.
The data is transmitted over four copper pairs, eight bits at a time. First, eight bits of data are expanded into four three-bit symbols through a non-trivial scrambling procedure based on a linear-feedback shift register; this is similar to what is done in 100BASE-T2, but uses different parameters. The three-bit symbols are then mapped to ...