Search results
Results from the WOW.Com Content Network
Spur gears or straight-cut gears are the simplest type of gear. They consist of a cylinder or disk with teeth projecting radially. Viewing the gear at 90 degrees from the shaft length (side on) the tooth faces are straight and aligned parallel to the axis of rotation. Looking down the length of the shaft, a tooth's cross section is usually not ...
Cycloid gear. Drawing showing the tooth and leaf profile of a cycloidal wheel and pinion. A cycloidal gear is a toothed gear with a cycloidal profile. Such gears are used in mechanical clocks and watches, rather than the involute gear form used for most other gears. Cycloidal gears have advantages over involute gears in such applications in ...
The involute gear profile, sometimes credited to Leonhard Euler, [ 1] was a fundamental advance in machine design, since unlike with other gear systems, the tooth profile of an involute gear depends only on the number of teeth on the gear, pressure angle, and pitch. That is, a gear's profile does not depend on the gear it mates with.
Profile of a spur gear Notation and numbering for an external gear Notation and numbering for an internal gear. The tooth surface (flank) forms the side of a gear tooth. [1] It is convenient to choose one face of the gear as the reference face and to mark it with the letter “I”. The other non-reference face might be termed face “II”.
A stepper motor, also known as step motor or stepping motor, [1] is an electric motor that rotates in a series of small angular steps, instead of continuously. [2] Stepper motors can be set to any given step position without needing a position sensor for feedback. The step position can be rapidly increased or decreased, creating continuous ...
Bevel gear. Bevel gears are gears where the axes of the two shafts intersect and the tooth -bearing faces of the gears themselves are conically shaped. Bevel gears are most often mounted on shafts that are 90 degrees apart, but can be designed to work at other angles as well. [ 1] The pitch surface of bevel gears is a cone, known as a pitch cone.
The old method of gear cutting is mounting a gear blank in a shaper and using a tool shaped in the profile of the tooth to be cut. This method also works for cutting internal splines. Another is a pinion-shaped cutter that is used in a gear shaper machine. It is basically when a cutter that looks similar to a gear cuts a gear blank.
Differential (mechanical device) A differential is a gear train with three drive shafts that has the property that the rotational speed of one shaft is the average of the speeds of the others. A common use of differentials is in motor vehicles, to allow the wheels at each end of a drive axle to rotate at different speeds while cornering.