enow.com Web Search

  1. Ads

    related to: usb to data transfer cable

Search results

  1. Results from the WOW.Com Content Network
  2. USB-to-serial adapter - Wikipedia

    en.wikipedia.org/wiki/USB-to-serial_adapter

    FTDI US232R : USB to RS-232 cable. A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data.

  3. USB - Wikipedia

    en.wikipedia.org/wiki/USB

    USB bridge cables, or data transfer cables can be found within the market, offering direct PC to PC connections. A bridge cable is a special cable with a chip and active electronics in the middle of the cable. The chip in the middle of the cable acts as a peripheral to both computers and allows for peer-to-peer communication between the computers.

  4. USB communications - Wikipedia

    en.wikipedia.org/wiki/USB_communications

    USB signals are transmitted using differential signaling on a twisted-pair data cable with 90 Ω ± 15% characteristic impedance. [6] Low speed (LS) and Full speed (FS) modes use a single data pair, labelled D+ and D−, in half-duplex. Transmitted signal levels are 0.0–0.3 V for logical low, and 2.8–3.6 V for logical high level.

  5. USB hardware - Wikipedia

    en.wikipedia.org/wiki/USB_hardware

    Such devices can use an external power supply, which is allowed by the standard, or use a dual-input USB cable, one input of which is for power and data transfer, the other solely for power, which makes the device a non-standard USB device. Some USB ports and external hubs can, in practice, supply more power to USB devices than required by the ...

  6. USB4 - Wikipedia

    en.wikipedia.org/wiki/USB4

    Unlike USB 2.0 and USB 3.x it does not provide a way to transfer data directly, but rather it is a mere container that can contain multiple "tunnels"/virtual connections. Other specifications are referenced to define the contents and internal functionality of a tunnel. USB4 defines the following tunnel types: USB3 connections; DisplayPort ...

  7. Direct cable connection - Wikipedia

    en.wikipedia.org/wiki/Direct_cable_connection

    Therefore, Direct Cable Connection over USB is not possible; a USB link cable must be used, as seen in the Microsoft knowledge base article 814982. However, with a USB link cable, a program which supports data transfer using that cable must be used. Typically, such a program is supplied with the USB link cable.

  1. Ads

    related to: usb to data transfer cable