Search results
Results from the WOW.Com Content Network
Polycarbonate is commonly used in eye protection, as well as in other projectile-resistant viewing and lighting applications that would normally indicate the use of glass, but require much higher impact-resistance. Polycarbonate lenses also protect the eye from UV light.
In fracture mechanics, the energy release rate, , is the rate at which energy is transformed as a material undergoes fracture. Mathematically, the energy release rate is expressed as the decrease in total potential energy per increase in fracture surface area, [ 1 ] [ 2 ] and is thus expressed in terms of energy per unit area.
Typical rates in aluminium foil laminates may be as low as 0.001 g/m 2 /day, whereas the rate in fabrics can measure up to several thousand g/m 2 /day. [citation needed] Often, barrier testing is conducted on a sheet of material. Calculations based on that can be useful when designing completed structures, clothing, and packages.
MFI Measuring device. The Melt Flow Index (MFI) is a measure of the ease of flow of the melt of a thermoplastic polymer.It is defined as the mass of polymer, in grams, flowing in ten minutes through a capillary of a specific diameter and length by a pressure applied via prescribed alternative gravimetric weights for alternative prescribed temperatures.
Values of range from below 25 for very dense flint glasses, around 34 for polycarbonate plastics, up to 65 for common crown glasses, and 75 to 85 for some fluorite and phosphate crown glasses. Most of the human eye's wavelength sensitivity curve, shown here, is bracketed by the Abbe number reference wavelengths of 486.1 nm (blue) and 656.3 nm (red)
A polycarbonate is an oxocarbon dianion consisting of a chain of carbonate units, where successive carbonyl groups are directly linked to each other by shared additional oxygen atoms. That is, they are the conjugate bases of polycarbonic acids , the conceptual anhydrides of carbonic acid , or polymers of carbon dioxide .
The degree of polymerization, or DP, is the number of monomeric units in a macromolecule or polymer or oligomer molecule. [1] [2] [3]For a homopolymer, there is only one type of monomeric unit and the number-average degree of polymerization is given by ¯ ¯ = ¯, where ¯ is the number-average molecular weight and is the molecular weight of the monomer unit.
Traditionally, the wear of materials has been characterized by weight loss and wear rate. However, studies have found that wear coefficient is more suitable. The reason being that it takes the wear rate, the applied load, and the hardness of the wear pin into account. Although, measurement variations by an order of 10-1 have been observed, the ...