enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Head tube - Wikipedia

   en.wikipedia.org/wiki/Head_tube

   The steering axis angle, also called caster angle, is the angle that the head tube and hence the steering axis makes with the horizontal or vertical, depending on convention. The steering axis is the axis about which the steering mechanism (fork, handlebars, front wheel, etc.) pivots.

3. Stem (bicycle part) - Wikipedia

   en.wikipedia.org/wiki/Stem_(bicycle_part)

   Quill stem classic single-piece type Threadless stem shown with cable hole. The stem is the component on a bicycle that connects the handlebars to the steerer tube of the bicycle fork. Sometimes called a goose neck, [1] a stem's design belongs to either a quill or threadless system, and each system is compatible with respective headset and fork ...

4. Headset (bicycle part) - Wikipedia

   en.wikipedia.org/wiki/Headset_(bicycle_part)

   A threadless headset and fork is marginally lighter than an equivalent threaded headset and fork. A threadless stem is more rigidly attached to the forks, giving improved rigidity at the handlebars. On bicycles which have not been maintained, water can find its way between the stem and steerer tube of threaded headsets, causing corrosion and ...

5. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

6. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   Typically, many rifles use thread diameters in the range between 25–27 mm (0.98–1.06 in). [ citation needed ] Many older rifles from the first half of the 20th century use a thread pitch around 2 mm (12.7 TPI), while many modern rifle use thread pitches around 1.5 mm (16.93 TPI).

7. Trapezoidal thread form - Wikipedia

   en.wikipedia.org/wiki/Trapezoidal_thread_form

   The actual thread heights on both the internal (nut) and external (bolt) threads differ from ⁠ P / 2 ⁠ by allowances (or clearances): A minimum root-crest clearance of 0.01 in (0.25 mm) (diametral) between opposing threads with 10 tpi (threads-per-inch) or fewer, and 0.005 in (0.13 mm) for finer pitches.