Search results
Results from the WOW.Com Content Network
This innovation was introduced in the Carver TX-1-11 component FM stereo tuner noise reduction unit and the Carver TX-11 AM/FM Stereo Tuner in 1982. Sunfire Corporation: The creation of the perfect solid-state amplifier: 1) Full output current from each transistor is always available up to 20 amperes per transistor.
QSC is an American manufacturer of audio, video and control products such as amplifiers, loudspeakers, cameras, video endpoints, and digital signal processors including the Q-SYS networked audio, video and control platform. QSC and Q-SYS products are used by audio and video professionals for commercial applications, including corporate, higher ...
Loudspeaker time-alignment, usually simply referred to as "time-alignment" or "Time-Align", is a term applied in loudspeaker systems which use multiple drivers (like woofer, mid-range and tweeter) to cover a wide audio range. It involves delaying the sound emanating from one or more drivers (greater than 2-way) to correct the transient response ...
It was a design collaboration by Bob Carver and Bill Skinner. The company was known for the most powerful audio amplifiers of the era led by the Phase Linear D-500 introduced in 1978. It was a stereo power amplifier delivering 505 watts of clean (typically < 0.1% total harmonic distortion over 20 Hz–20 kHz) RMS power per channel.
A loudspeaker enclosure or loudspeaker cabinet is an enclosure (often rectangular box-shaped) in which speaker drivers (e.g., loudspeakers and tweeters) and associated electronic hardware, such as crossover circuits and, in some cases, power amplifiers, are mounted.
Audio feedback from microphones occurs when a microphone is too near a monitor or main speaker and the sound reinforcement system amplifies itself. Audio feedback through a microphone is almost universally regarded as a negative phenomenon, many electric guitarists use guitar feedback as part of their performance.
Depending on local practices, these amplifiers usually amplify the audio signals to 50 V, 70 V, or 100 V speaker line level. [16] Control equipment monitors the amplifiers and speaker lines for faults before it reaches the loudspeakers. This control equipment is also used to separate zones in a PA system.
Loudspeakers are often classified as "N-way", where N is the number of drivers in the system. For instance, a loudspeaker with a woofer and a tweeter is a 2-way loudspeaker system. An N-way loudspeaker usually has an N-way crossover to divide the signal among the drivers. A 2-way crossover consists of a low-pass and a high-pass filter.