Ads
related to: pull up resistor
Search results
Results from the WOW.Com Content Network
In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. [1] It is typically used in combination with components such as switches and transistors , which physically interrupt the connection of subsequent components to ground or to V CC .
Pull-up resistors are provided by the I3C controller. External pull-up resistors are no longer needed. Clock Stretching – devices are expected to be fast enough to operate at bus speed. The I3C controller is the sole clock source. I²C Extended (10-bit) Addresses. All devices on an I3C bus are addressed by a 7-bit address.
A 1-Wire network is a single open drain wire with a single pull-up resistor. The pull-up resistor pulls the wire up to 3 or 5 volts. The master device and all the slaves each have a single open-drain connection to drive the wire, and a way to sense the state of the wire.
The output is usually connected to an external pull-up resistor, which pulls the output voltage to the resistor's supply voltage when the transistor is off. For PNP open collector outputs, the emitter of the PNP transistor is internally connected to the positive voltage rail , so the collector outputs a high voltage when the transistor is on or ...
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
An active-low OR diode logic gate is formed by a keypad containing diodes at each switch, all connected to a shared pull-up resistor. When no switch is closed, the pull-up keeps the output high. But when the switch for any key connects to ground, the output goes low. This OR result can be used as an interrupt signal to indicate that any key has ...
See also: Diode logic § Active-high AND logic gate Open-collector buffers connected as wired AND.. The wired AND connection is a form of AND gate.When using open collector or similar outputs (which can be identified by the ⎐ symbol in schematics), wired AND only requires a pull up resistor on the shared output wire.
The voltage drop across any resistor depends on the current flowing; in a circuit, currents can change and consequently the voltages at specific points in that circuit may go up at one end of what is called a pull-up resistor, or down at one end of what is called a pull-down resistor.
Ads
related to: pull up resistor