Search results
Results from the WOW.Com Content Network
The basic difference between a parallel and a serial communication channel is the number of electrical conductors used at the physical layer to convey bits. Parallel communication implies more than one such conductor. For example, an 8-bit parallel channel will convey eight bits (or a byte) simultaneously, whereas a serial channel would convey ...
Parallel transmission is the simultaneous transmission of related signal elements over two or more separate paths. Multiple electrical wires are used that can transmit multiple bits simultaneously, which allows for higher data transfer rates than can be achieved with serial transmission.
Serial computer buses have become more common even at shorter distances, as improved signal integrity and transmission speeds in newer serial technologies have begun to outweigh the parallel bus's advantage of simplicity (no need for serializer and deserializer, or SerDes) and to outstrip its disadvantages (clock skew, interconnect density).
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
Analog transmission is a transmission method of conveying information using a continuous signal which varies in amplitude, phase, or some other property in proportion to that information. It could be the transfer of an analog signal , using an analog modulation method such as frequency modulation (FM) or amplitude modulation (AM), or no ...
Asynchronous start-stop is the lower data-link layer used to connect computers to modems for many dial-up Internet access applications, using a second (encapsulating) data link framing protocol such as PPP to create packets made up out of asynchronous serial characters. The most common physical layer interface used is RS-232D.
The dual-mode hybrid concept, as described in 1994, was developed to optimize vehicle efficiency by switching between parallel and series hybrid operation, taking advantage of series operation in stop-and-go traffic to minimize engine speed variance, and parallel operation at highway speeds to use efficient mechanical transmission.
Programmed input–output (also programmable input/output, programmed input/output, programmed I/O, PIO) is a method of data transmission, via input/output (I/O), between a central processing unit (CPU) and a peripheral device, [1] such as a Parallel ATA storage device. Each data item transfer is initiated by an instruction in the program ...