Search results
Results from the WOW.Com Content Network
Semi-automatic transmissions were almost exclusively used in motorcycles and are based on conventional manual transmissions or sequential manual transmissions, but use an automatic clutch system. But some semi-automatic transmissions have also been based on standard hydraulic automatic transmissions with torque converters and planetary gearsets ...
They are much less common than motorcycles with conventional manual transmissions, typically use a centrifugal clutch, and are mostly found on smaller motorcycles, such as minibikes, underbone (step-thru) motorcycles (e.g., the Honda Super Cub), smaller dirt bikes (such as pit bikes), and various (mostly older) mopeds and motor scooters. Semi ...
The CVT drive belt would derail and seize the transmission and the rear wheel, disabling the scooter and also preventing it from being pushed. Also, the starting procedure for the Tina required moving a switch on the handlebar to "start" before kick starting the scooter; this activated a governor to keep the engine speed too low to activate the ...
The term scooty has become the generic term for scooter in India [1]. A scooter (motor scooter) is a motorcycle with an underbone or step-through frame, a seat, a transmission that shifts without the operator having to operate a clutch lever, a platform for their feet, and with a method of operation that emphasizes comfort and fuel economy.
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
Depending on whether the motorcycle has a manual hand clutch or an automatic centrifugal clutch, determines whether the motorcycle transmission is a semi-automatic (automatic clutch) or a manual transmission. It is then coupled to a sprocket and chain drive to transmit power to the rear wheel.
A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. [1] The clutch's input shaft is typically attached to a motor, while the clutch's output shaft is connected to the mechanism that does the work. In a motor vehicle, the clutch acts as a mechanical linkage between the engine and ...
The Honda PC50 is a moped produced by the Honda Motor Company in Japan from May 1969 until at least 1983. The PC50, though much smaller and lighter, had some similar features to Honda's popular C50 /70 /90 Super Cub line, with a step-through pressed-steel frame, a fuel tank under the saddle, a chain cover, and optionally equipped with leg shields,