Search results
Results from the WOW.Com Content Network
Semi-automatic transmissions were almost exclusively used in motorcycles and are based on conventional manual transmissions or sequential manual transmissions, but use an automatic clutch system. But some semi-automatic transmissions have also been based on standard hydraulic automatic transmissions with torque converters and planetary gearsets ...
They are much less common than motorcycles with conventional manual transmissions, typically use a centrifugal clutch, and are mostly found on smaller motorcycles, such as minibikes, underbone (step-thru) motorcycles (e.g., the Honda Super Cub), smaller dirt bikes (such as pit bikes), and various (mostly older) mopeds and motor scooters. Semi ...
The term scooty has become the generic term for scooter in India [1]. A scooter (motor scooter) is a motorcycle with an underbone or step-through frame, a seat, a transmission that shifts without the operator having to operate a clutch lever, a platform for their feet, and with a method of operation that emphasizes comfort and fuel economy.
The CVT drive belt would derail and seize the transmission and the rear wheel, disabling the scooter and also preventing it from being pushed. Also, the starting procedure for the Tina required moving a switch on the handlebar to "start" before kick starting the scooter; this activated a governor to keep the engine speed too low to activate the ...
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
A chainsaw's clutch. The chain wraps around a sprocket behind the clutch that turns with the outer drum. The input of the clutch is connected to the engine crankshaft while the output may drive a shaft, chain, or belt. As engine revolutions per minute increase, weighted arms in the clutch swing outward and force the clutch to engage. The most ...
There is no clutch of any kind between the CVT and the crankshaft; it is engaged via a centrifugal clutch at the rear pulley in the same fashion as Vespa Grande, Bravo, and variated Ciao model, as well as Honda Camino/Hobbit scooters/mopeds. An electric starter, backup kick-starter, and rear brake hardware is also housed in the swingarm. [2]
The original V50 had a 49 cc (3.0 cu in) two-stroke engine with a three speed semi-automatic gearbox and could reach speeds of about 35–40 mph (56–64 km/h). The problem with this model was that in the UK in the early 1970s to ride a 50 cc moped on a learner licence the bike needed to have pedals.