Search results
Results from the WOW.Com Content Network
Semi-automatic transmissions were almost exclusively used in motorcycles and are based on conventional manual transmissions or sequential manual transmissions, but use an automatic clutch system. But some semi-automatic transmissions have also been based on standard hydraulic automatic transmissions with torque converters and planetary gearsets ...
The CVT drive belt would derail and seize the transmission and the rear wheel, disabling the scooter and also preventing it from being pushed. Also, the starting procedure for the Tina required moving a switch on the handlebar to "start" before kick starting the scooter; this activated a governor to keep the engine speed too low to activate the ...
A chainsaw's clutch. The chain wraps around a sprocket behind the clutch that turns with the outer drum. The input of the clutch is connected to the engine crankshaft while the output may drive a shaft, chain, or belt. As engine revolutions per minute increase, weighted arms in the clutch swing outward and force the clutch to engage. The most ...
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
They are much less common than motorcycles with conventional manual transmissions, typically use a centrifugal clutch, and are mostly found on smaller motorcycles, such as minibikes, underbone (step-thru) motorcycles (e.g., the Honda Super Cub), smaller dirt bikes (such as pit bikes), and various (mostly older) mopeds and motor scooters. Semi ...
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
Some motor scooters include a centrifugal clutch, to assist when idling or manually reversing the scooter. [48] The 1974 Rokon RT340 TCR Automatic off-road motorcycle was fitted with a snowmobile CVT. The first ATV equipped with a CVT was the Polaris Trail Boss in 1985. [citation needed]