Search results
Results from the WOW.Com Content Network
Sensors measuring the paper quality (online meters) are attached to a sensor platform that move across the web guided by the scanner beam. A typical crossing time for a sensor platform is 10–30 s (an 8 m web, 60 cm/s). The sensor platform scans across the paper web and continuously measures paper characteristics from edge to edge.
Set-off is measured at two different time intervals, 0.35s and 3s. A freshly printed surface is pressed against a paper after 0.35s and after 3s. Then the set-off density is measured. The idea behind selecting these two timings is to know what will be the set-off when the materials are used in a high-speed press and a low-speed press.
The density can be calculated by dividing the grammage of paper (in grams per square metre or "gsm") by its caliper (usually in micrometres, occasionally in mils). [1] The "ISO 534:2011, Paper and board — Determination of thickness, density and specific volume" indicates that the paper density is expressed in grams per cubic centimeter (g/cm ...
The basis weight of paper is the density of paper expressed in terms of the mass of a ream of given dimensions and a sheet count. In the US system, the weight is specified in avoirdupois pounds and the sheet count of a paper ream is usually 500 sheets. However, the mass specified is not the mass of the ream that is sold to the customer.
At the interface between the phases (in the classical problem) the temperature is set to the phase change temperature. To close the mathematical system a further equation, the Stefan condition, is required. This is an energy balance which defines the position of the moving interface.
2850 2100 1600 1250 1000 670 500 400 340 300 247 237 235 236 237 240 240 ... Dry Zero − Kapok between burlap or paper density 0.016 g cm ... K. T. Yucel et al. 0. ...
It is an extremely radioactive element that has only been created in a laboratory setting and has not been observed in nature. The element is named after the Lawrence Livermore National Laboratory in the United States, which collaborated with the Joint Institute for Nuclear Research (JINR) in Dubna , Russia, to discover livermorium during ...
The neutral density ( ) or empirical neutral density is a density variable used in oceanography, introduced in 1997 by David R. Jackett and Trevor McDougall. [1] It is a function of the three state variables ( salinity , temperature , and pressure ) and the geographical location ( longitude and latitude ).