enow.com Web Search

  1. Ads

    related to: 2 position coax antenna switch for tv receiver with remote working

Search results

  1. Results from the WOW.Com Content Network
  2. Low-noise block downconverter - Wikipedia

    en.wikipedia.org/wiki/Low-noise_block_downconverter

    And there are also available four feed monoblock LNB units, which enable users to receive signals from four satellites, for example Eurobird 9°E, Hotbird 13°E, Astra 19.2°E and Astra 23.5°E (4°+6.2°+4.3°=14.5°spacing). Most receivers sold nowadays are compatible with at least DiSeqC 1.0 which allows to switch automatically between 4 ...

  3. Belling-Lee connector - Wikipedia

    en.wikipedia.org/wiki/Belling-Lee_connector

    Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...

  4. Television antenna - Wikipedia

    en.wikipedia.org/wiki/Television_antenna

    The standard today is 75 ohm coaxial cable, which is less susceptible to interference which plugs into an F connector or Belling-Lee connector (depending on region) on the back of the TV. [6] To convert the signal from antennas that use a twin-lead line to the modern coaxial cable input, a small transformer called a balun is used in the line.

  5. DiSEqC - Wikipedia

    en.wikipedia.org/wiki/DiSEqC

    2-way DiSEqC switch 4-way DiSEqC switch with attached coaxial cables.. DiSEqC (/ ˈ d aɪ s ɛ k, d aɪ ˈ s ɛ k s i /; [citation needed] short for Digital Satellite Equipment Control) is a special communication protocol for use between a satellite receiver and a device such as a multi-dish switch or a small [1] dish antenna rotor.

  6. List of RF connector types - Wikipedia

    en.wikipedia.org/wiki/List_of_RF_connector_types

    A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

  7. RF connector - Wikipedia

    en.wikipedia.org/wiki/RF_connector

    Various popular RF connectors Electronic symbols for the plug and jack coaxial connectors Time-domain reflectometry shows reflections due to impedance variations in mated RF connectors. An RF connector ( radio frequency connector ) is an electrical connector designed to work at radio frequencies in the multi-megahertz range.

  1. Ads

    related to: 2 position coax antenna switch for tv receiver with remote working