Search results
Results from the WOW.Com Content Network
Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...
In the most basic form, a quarter-wavelength section of coaxial cable is prepared such that the inner and outer conductors are separate but still attached to the remaining cable. The outer (shield) conductor is connected to a quarter-wavelength conducting sleeve into which the cable is inserted, and the inner conductor protrudes vertically ...
The antenna feed system or antenna feed is the cable or conductor, and other associated equipment, which connects the transmitter or receiver with the antenna and makes the two devices compatible. [ 1 ] [ 2 ] In a radio transmitter, the transmitter generates an alternating current of radio frequency , and the feed system feeds the current to ...
A wiring diagram usually gives information about the relative position and arrangement of devices and terminals on the devices, to help in building or servicing the device. This is unlike a schematic diagram , where the arrangement of the components' interconnections on the diagram usually does not correspond to the components' physical ...
Twinaxial plug (style used by IBM; [1] other designs exist [2]) Twinaxial cabling, or twinax, is a type of cable similar to coaxial cable, but with two inner conductors in a twisted pair instead of one. [3] Due to cost efficiency it is becoming common in modern (2013) very-short-range high-speed differential signaling applications.
Hybrid fiber-coaxial (HFC) is a broadband telecommunications network that combines optical fiber and coaxial cable. It has been commonly employed globally by cable television operators since the early 1990s.
The flange design, inner and outer conductor dimensions are standardized, by EIA, in the RS-225, 50 Ω (ohm), and RS-259, 75 Ω, standards.They are commonly referred to by the inner diameter of the outer conductor in fractional inches.
They are also common on USB DVB-T tuners for computers and laptops, to connect an external antenna to the tuner. The MCX connector is also being used on at least some of the new generation of mostly inexpensive software-defined oscilloscopes and/or signal generators such as the DS212. This is a low frequency application, at most a few MHz ...