enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Shaft collar - Wikipedia

   en.wikipedia.org/wiki/Shaft_collar

   Two-piece clamp-style shaft collars can be disassembled or installed in position without having to remove other components from the shaft. The two-piece design provides greater clamping force than a single piece clamp because all of the force is transferred directly into clamping the shaft. Also, the two piece collar has double the amount of ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Copper fittings for soldered joints. Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...

4. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   The clevis is a U-shaped piece that has holes at the end of the prongs to accept the clevis pin. The clevis pin is similar to a bolt, but is either partially threaded or unthreaded with a cross-hole for a split pin. A tang is a piece that is sometimes fitted in the space within the clevis and is held in place by the clevis pin.

5. Screw mechanism - Wikipedia

   en.wikipedia.org/wiki/Screw_mechanism

   A machine used in schools to demonstrate the action of a screw, from 1912. It consists of a threaded shaft through a threaded hole in a stationary mount. When the crank on the right is turned, the shaft moves horizontally through the hole. The screw is a mechanism that converts rotational motion to linear motion, and a torque (rotational force ...

6. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Collet. A W-type external-thread collet (red) being pulled into its spindle seat (green) with a drawbar (blue), clamping, rotating and then releasing a shaft. A collet / ˈkɒlɪt / is a segmented sleeve, band or collar. [1][2] One of the two radial surfaces of a collet is usually tapered (i.e a truncated cone) and the other is cylindrical.

7. Cue stick - Wikipedia

   en.wikipedia.org/wiki/Cue_stick

   The heavy, lower piece of the cue is the cue butt, and the smaller, narrower end is the shaft. The two cue pieces are attached at the joint; normally a screw rising from butt end's joint (male) is threaded into a receptacle on the shaft (female), or vice versa.