enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. SATA - Wikipedia

   en.wikipedia.org/wiki/SATA

   The eSATA cable and connector is similar to the SATA 1.0a cable and connector, with these exceptions: The eSATA connector is mechanically different to prevent unshielded internal cables from being used externally. The eSATA connector discards the L-shaped key and changes the position and size of the guides.

3. SATA Express - Wikipedia

   en.wikipedia.org/wiki/SATA_Express

   SATA Express host-side connector, formally known as the "host plug", accepts both SATA Express and legacy standard SATA data cables. [13] [31]Connectors used for SATA Express were selected specifically to ensure backward compatibility with legacy SATA devices where possible, without the need for additional adapters or converters. [2]

4. Hard disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Hard_disk_drive_interface

   The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.

5. eSATAp - Wikipedia

   en.wikipedia.org/wiki/ESATAp

   eSATAp cables are available with wide connectors to plug directly into the power and signal connectors of a bare drive, providing a 12 V supply in the case of a desktop machine. A version of this wide connector is found inside every external SATA hard drive enclosure; when the hard drive is slid inside, it mates with a connector that supplies ...

6. U.2 - Wikipedia

   en.wikipedia.org/wiki/U.2

   U.3 (SFF-TA-1001) is built on the U.2 spec and uses the same SFF-8639 connector. A single "tri-mode" (PCIe/SATA/SAS) backplane receptacle can handle all three types of connections; the controller automatically detects the type of connection used. This is unlike U.2, where users need to use separate controllers for SATA/SAS and NVMe.

7. Parallel ATA - Wikipedia

   en.wikipedia.org/wiki/Parallel_ATA

   Starting with the 80-conductor cable defined for use in ATAPI5/UDMA4, the master Device 0 device goes at the far-from-the-host end of the 18-inch (460 mm) cable on the black connector, the slave Device 1 goes on the grey middle connector, and the blue connector goes to the host (e.g. motherboard IDE connector, or IDE card).