Search results
Results from the WOW.Com Content Network
A simple miter gauge. A miter gauge is a device used for holding workpieces at a set angle while being cut on table saws, band saws or sanded on stationary disk sanders.The miter gauge slides in a slot on the worktable (known as a miter slot) on the machine being used.
A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...
The blade of a table saw cutting into wood. A table saw (also known as a sawbench or bench saw in England) is a woodworking tool, consisting of a circular saw blade, mounted on an arbor, that is driven by an electric motor (directly, by belt, by cable, or by gears).
Electric compound miter saw. A compound miter saw, also known as a chop saw is a stationary saw used for making precise cuts across the grain path of a board. These cuts can be at any chosen angle that the particular saw is capable of. [20] Table saw Electric plug-in tablesaw for woodworking. A table saw is intended to make long precise cuts ...
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
A cutting or fretwork table, also known as a V-board, made of either wood or metal and which clamps to the edge of the workbench, may be used to support the work piece whilst allowing clearance for the saw blade by means of a V-shaped slot cut into it. The blade is usually clamped into position using a pair of wingnuts. Although wing nuts are ...
Using a try square to mark lines perpendicular to the edge. Using a try square to check if the full length of a board is square. The stock is usually held against the edge of the workpiece and either side of the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle.
A jack plane is a general-purpose woodworking bench plane, used for dressing timber down to size in preparation for truing and/or edge jointing.It is usually the first plane used on rough stock, but for rougher work it can be preceded by the scrub plane. [1]