Search results
Results from the WOW.Com Content Network
Polymer capacitors, tantalum as well as aluminum, are reliable at the same high level as other electronic components with very low failure rates. However, all tantalum electrolytic capacitors, including polymer tantalum, have a unique failure mode called "field crystallization". [75]
More than 90% of the today's rare failures in tantalum solid-state electrolytic capacitors are caused by shorts or increased leakage current due to this failure mode. [ 70 ] The extremely thin oxide film of a tantalum electrolytic capacitor, the dielectric layer, must be formed in an amorphous structure.
Structurally, capacitors consist of electrodes separated by a dielectric, connecting leads, and housing; deterioration of any of these may cause parameter shifts or failure. Shorted failures and leakage due to increase of parallel parasitic resistance are the most common failure modes of capacitors, followed by open failures.
Failure mode and effects analysis (FMEA; often written with "failure modes" in plural) is the process of reviewing as many components, assemblies, and subsystems as possible to identify potential failure modes in a system and their causes and effects. For each component, the failure modes and their resulting effects on the rest of the system ...
The failure mode may then be charted on a criticality matrix using severity code as one axis and probability level code as the other. For quantitative assessment, modal criticality number is calculated for each failure mode of each item, and item criticality number is calculated for each item. The criticality numbers are computed using the ...
Fortunately, most solid tantalum capacitor failures will be immediate and very evident. Once in application solid tantalum capacitor performance will improve over time and the chances of a failure due to component mis-manufacturing decrease. Wet tantalums are a type of the electrolytic capacitor, using a tantalum pellet in an electrolytic ...
They were still less expensive than tantalum capacitors and with their flat design for laptops and cell phones competed with tantalum chip capacitors as well. Tantalum electrolytic capacitors with PPy polymer electrolyte cathode followed three years later. In 1993 NEC introduced its SMD polymer tantalum electrolytic capacitors, called "NeoCap".
The loss tangent is defined by the angle between the capacitor's impedance vector and the negative reactive axis. If the capacitor is used in an AC circuit, the dissipation factor due to the non-ideal capacitor is expressed as the ratio of the resistive power loss in the ESR to the reactive power oscillating in the capacitor, or