Search results
Results from the WOW.Com Content Network
Inside the self-sealing suction cup, the plug is positioned close to the tube opening so that it can get sucked into the tube seal the hole when the central suction line is powered. A pair of springs connected to the suction cup's base helps maintain the plug's position, restoring the plug seal in the absence of object forces.
Hoist atop an elevator. A hoist is a device used for lifting or lowering a load by means of a drum or lift-wheel around which rope or chain wraps. It may be manually operated, electrically or pneumatically driven and may use chain, fiber or wire rope as its lifting medium.
The hold downs provide uplift resistance against the overturning moment imposed on the wall due to "in-plane" lateral load applied at the top of the wall. A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1]
The lewis hole seating is undercut (similar to a chain-linked lewis hole) to match its profile. The first outer leg is inserted into the lewis hole, followed by the second outer leg. The inner (parallel) leg is inserted last, pushing the outer legs into contact with the inside of the lewis hole.
Establishing the lifting anchor positions will influence the rigging arrangements used and therefore the static analysis of the rigging should be determined. Particular rigging configurations may be more suitable for particular job sites or lifting in place considerations, and the lifting design should denote the assumptions accordingly.
The working face of the suction cup is made of elastic, flexible material and has a curved surface. [3] When the center of the suction cup is pressed against a flat, non-porous surface, the volume of the space between the suction cup and the flat surface is reduced, which causes the air or water between the cup and the surface to be expelled past the rim of the circular cup.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Crude versions of conically tapered ground glass joints have been made for quite a while, [1] particularly for stoppers for glass bottles and retorts. [2] Crude glass joints could still be made to seal well by grinding the two parts of a joint against each other using an abrasive grit, but this led to variations between joints and they would not seal well if mated to a different joint.