Search results
Results from the WOW.Com Content Network
A base can thus sometimes constitute a complete scope mount assembly, but is most often used to refer to the lower part of a two-part scope mount assembly. The firearm interface which sits on the firearm and to which the scope mount is attached is often called the base or rail. Some types of bases are: Standard mounts
F14 Compass, lensatic, M1918 – Parts and equipment, 16 September 1927; F15 Machine gun clinometer M1917 Parts and equipment; F16 Sight, panoramic, machine gun, M1918 – Parts and equipment; F17 Device, aiming, mirror, M1918 – Parts and equipment, 23 November 1926; F18 Night lighting device, parts and equipment; F19 Board, deflection, M1; F20
The SIG Sauer 200 STR has an 11 mm dovetail on the receiver for mounting a diopter rear sight or a scope sight, either directly or via a Picatinny rail adapter.. Dovetails come in several different types and sizes depending on manufacturer, but the most common are the 11 mm and 3 ⁄ 8 inch (9.5 mm).
Casemate-mounted 5"/50 caliber gun on the USS North Dakota. A casemate is an armoured structure consisting of a static primary surface incorporating a limited-traverse gun mount: typically, this takes the form of either a gun mounted through a fixed armour plate (typically seen on tank destroyers and assault guns) or a mount consisting of a partial cylinder of armour "sandwiched" between ...
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]
The locking bar system allows for even stress to be distributed and prevent canting of the scope mount. Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place.
A Zeiss rail system typically adds height to the scope body, but also gives the possibility for a slimmer scope mount so that the total scope height can become comparable to a traditional ring mount. The added scope body height due to the rail piece on the scope itself contributes about 5.5 mm (0.22 in) to the total height.
The M27's mount is interchangeable with the XM8 system. [56] As with the XM8, this system can also be mounted on the OH-58 Kiowa. HGS-55. Using a mount similar to that used on the XM8 and M27 series, the HGS-55 was developed by the McDonnell Douglas Helicopter Company (formerly Hughes Helicopters) to use the EX 34 Mod 0 7.62×51mm chain gun. [57]