Search results
Results from the WOW.Com Content Network
It was available as a 4,146 cubic centimeters (4.146 L; 253.0 cu in) four-cylinder engine, but the engine was also available as a 5,942 cubic centimeters (5.942 L; 362.6 cu in) or 6,218 cubic centimeters (6.218 L; 379.4 cu in) six-cylinder engine.
The 4G52 displaces 2.0 L (1,995 cc). Peak power for a 1975 Canter is 100 PS (74 kW), but power increased to as much as 125 PS (92 kW) for the twin-carb version fitted to the Galant GTO GSR and A115 Galant GS-II. Used an 84 mm × 90 mm (3.31 in × 3.54 in) bore and stroke. In Australia this engine was used in the Sigma, Scorpion and L200.
As of 2008, variations of the original 3.6-litre engines became the Mercruiser D4.2L/220 IDI six-cylinder diesel. Parts for BMW Marine engines continue to be available from Mercury Marine and their subsidiary, Marine Power, in Belgium. Some of the original 200 BMW Marine dealers worldwide continue to service and sell parts.
The 4JA1-CR / 4JA1 Blue Power is a Euro 4 variant of 4JA1-L. Unlike its predecessor which used conventional Direct Injection, it uses a High Pressure Common rail Direct Injection system and Diesel particulate filter, [40] thus achieving Euro 4 emission. Power rated at 78 PS (57 kW) at 3900 rpm and 176.5 N⋅m (18.00 kg⋅m) at 1800 rpm.
Shale shaker (#2) separates drill cuttings from the drilling fluid before it is pumped back down the wellbore. Stand (#16) is a section of 2 or 3 joints of drill pipe connected and stood upright in the derrick. When they are pulled out of the hole, instead of laying down each joint of drill pipe, 2 or 3 joints are left connected and stood in ...
On marine vessels the Power Management System PMS is in charge of controlling the electrical system. Its task is to make sure that the electrical system is safe and efficient. If the power consumption is larger than the power production capacity, load shedding is used to avoid blackout.
Outboard Marine Corporation sometimes referred to as Outboard Motor Company was formed in 1929 when ELTO was merged with Lockwood-Ash Motor Company. They began using the name OMC in 1956. Outboard Marine Corporation was the world's largest manufacturer and supplier of outboard motors and second largest producer of powerboats.
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.