Search results
Results from the WOW.Com Content Network
The model E had been developed by 1922; this could be said to be the "classic" Doble, of which the most examples have survived. The initial monotube boiler design was perfected into the "American" type. This produced steam at a pressure of 750 psi (52 bar) and a temperature of 750 °F (400 °C). The tubing was formed from seamless cold-drawn ...
A steam generator is a type of boiler used to produce steam for climate control and potable water heating in railroad passenger cars. The output of a railroad steam generator is low-pressure, saturated steam that is passed through a system of pipes and conduits throughout the length of the train. Steam generators were developed when diesel ...
The boiler in front is a partially dismantled Sentinel. A steam motor is a form of steam engine used for light locomotives and light self-propelled motor cars used on railways. [1] The origins of steam motor cars for railways go back to at least the 1850s, if not earlier, as experimental economizations for railways or railroads with marginal ...
Hose for conveying force to train brakes by a differential in air pressure. Contains either high-pressure compressed air or air at lower than atmospheric pressure (vacuum), depending on whether the locomotive has an air brake or vacuum brake system. [6]: 483–486 [3]: 1 Water compartment Tank for water to be used by the boiler to produce steam.
A high-pressure steam locomotive is a steam locomotive with a boiler that operates at pressures well above what would be considered normal for other locomotives. Most locomotives operate with a steam pressure of 200 to 300 psi (1.38 to 2.07 MPa). [1] In the later years of steam, boiler pressures were typically 200 to 250 psi (1.38 to 1.72 MPa).
On a steam locomotive, the cutoff is controlled by the reversing gear. The point at which the inlet valve closes and stops the entry of steam into the cylinder from the boiler plays a crucial role in the control of a steam engine. Once the valve has closed, steam trapped in the cylinder expands adiabatically. The steam pressure drops as it expands.
Although the definitions are somewhat flexible, it can be said that older steam generators were commonly termed boilers and worked at low to medium pressure (7–2,000 kPa or 1–290 psi) but, at pressures above this, it is more usual to speak of a steam generator. A boiler or steam generator is used wherever a source of steam is required.
The compact engine ran at considerable steam pressure, with the 10-horsepower (7.5 kW) boiler described in 1912 [6] as having the safety valve set at 650 pounds per square inch (4.5 MPa), with the burner set to automatically cut back when pressure reached 500 pounds per square inch (3.4 MPa).