Search results
Results from the WOW.Com Content Network
Some computers, particularly older ones, may not have a BIOS that supports USB booting. Many which do support USB booting may still be unable to boot the device in question. In these cases a computer can often be "redirected" to boot from a USB device through use of an initial bootable CD or floppy disk. [5] [6] [7]
Rufus was originally designed [5] as a modern open source replacement for the HP USB Disk Storage Format Tool for Windows, [6] which was primarily used to create DOS bootable USB flash drives. The first official release of Rufus, version 1.0.3 (earlier versions were internal/alpha only [ 7 ] ), was released on December 4, 2011, with originally ...
A modern PC is configured to attempt to boot from various devices in a certain order. If a computer is not booting from the device desired, such as the floppy drive, the user may have to enter the BIOS Setup function by pressing a special key when the computer is first turned on (such as Delete, F1, F2, F10 or F12), and then changing the boot order. [6]
The first stage of PC boot loaders (FSBL, first-stage boot loader) located on fixed disks and removable drives must fit into the first 446 bytes of the master boot record in order to leave room for the default 64-byte partition table with four partition entries and the two-byte boot signature, which the BIOS requires for a proper boot loader ...
A modern PC's UEFI or BIOS firmware supports booting from various devices, typically a local solid-state drive or hard disk drive via the GPT or Master Boot Record (MBR) on such a drive or disk, an optical disc drive (using El Torito), a USB mass storage device (USB flash drive, memory card reader, USB hard disk drive, USB optical disc drive ...
The Windows boot manager is located at the \EFI\Microsoft\Boot\ subfolder of the EFI system partition. [23] On Windows XP 64-Bit Edition and later, access to the EFI system partition is obtained by running the mountvol command. Mounts the EFI system partition on the specified drive. Available on Itanium-based computers only. [24]
The boot ROM of NXP systems on a chip (SOCs) support configuring the peripherals through specific pins of the system on a chip. On the i.MX6 family it also supports configuring the boot order through efuses. The boot ROM of several NXP SoCs have many ways to load the first stage bootloader (from eMMC, microSD, USB, etc.).
MemTest86(+) is designed to run as a stand-alone, self-contained program from a bootable USB flash drive, CD-ROM, floppy disk, or from a suitable boot manager without an operating system present. [24] This is because the program must directly control the hardware being tested and leave as much of the RAM space as possible for examination.