Search results
Results from the WOW.Com Content Network
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...
Networks are separated from each other by specialized hosts, called gateways or routers with specialized software support optimized for routing. IP forwarding algorithms in most routing software determine a route through a shortest path algorithm. In routers, packets arriving at an interface are examined for source and destination addressing ...
Hop-by-hop is the fundamental characteristic of the IP Internet layer [1] and the OSI Network Layer. When a router interface is configured with an IP address and subnet mask, the interface becomes a host on that attached network. A directly connected network is a network that is directly attached to one of the router interfaces.
A forwarding information base (FIB), also known as a forwarding table or MAC table, is most commonly used in network bridging, routing, and similar functions to find the proper output network interface controller to which the input interface should forward a packet. It is a dynamic table that maps MAC addresses to ports.
When an interface has an address configured in a subnet, such as 192.0.2.1 in the 192.0.2.0/24 (i.e., subnet mask 255.255.255.0) subnet, and that interface is considered "up" by the router, the router thus has a directly connected route to 192.0.2.0/24. If a routing protocol offered another router's route to that same subnet, the routing table ...
Routing loops are best avoided as they unnecessarily consume network resources. The underlying assumptions of an RPF check are that, the unicast routing table is correct and stable and, the path used from a sender to a router and the reverse path from the router back to the sender are symmetric.
The payload of an IPv6 packet is typically a datagram or segment of the higher-level transport layer protocol, but may be data for an internet layer (e.g., ICMPv6) or link layer (e.g., OSPF) instead. IPv6 packets are typically transmitted over the link layer (i.e., over Ethernet or Wi-Fi ), which encapsulates each packet in a frame .
The network has a fully meshed inner core of four nodes (0..3) and then four outer nodes (4,5,6 and 7), each dual-homed onto a pair of inner core nodes. Normally when nodes come from the factory they have a MAC address assigned which becomes a node identifier but for the purpose of this example we will assume that the nodes have MAC addresses ...