Search results
Results from the WOW.Com Content Network
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
Thrust lever or throttle, which controls engine speed or thrust for powered aircraft. The control yokes also vary greatly among aircraft. There are yokes where roll is controlled by rotating the yoke clockwise/counterclockwise (like steering a car) and pitch is controlled by moving the control column towards or away from the pilot, but in ...
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
The total load factor required to maintain level flight is directly related to the bank angle. This means that for a given airspeed, level flight can only be maintained up to a certain given angle of bank. Beyond this angle of bank, the aircraft will suffer an accelerated stall if the pilot attempts to generate enough lift to maintain level flight.
In adjustable-pitch propeller control system, the pilot has to adjust the propeller pitch angle and thus angle of attack of the propeller blades (typically with a lever) to achieve the desired propeller rotational speed. The increased pitch (blade angle of attack) increases the load on the engine and therefore slows it down, and vice versa.
To increase or decrease overall lift requires that the controls alter the angle of attack for all blades collectively by equal amounts at the same time, resulting in ascent, descent, acceleration and deceleration. A typical helicopter has three flight control inputs: the cyclic stick, the collective lever, and the anti-torque pedals. [2]
Thrust levers of an A320 set to the autothrust position during cruise flight. An autothrottle (automatic throttle, also known as autothrust, A/T or A/THR) is a system that allows a pilot to control the power setting of an aircraft's engines by specifying a desired flight characteristic, rather than manually controlling the fuel flow.
In contrast, a propeller set for good cruise performance may stall at low speeds, because the angle of attack is too high. A propeller with adjustable blade angle is more efficient over a range of conditions. A propeller with variable pitch can have a nearly constant efficiency over a range of airspeeds. [1]