Ad
related to: nail size for roof sheathingebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The purlins are the large beams perpendicular to the rafters; from this shot, it appears that there are three purlins on either side of the roof. The sheathing boards are sometimes called the roof deck and are painted white. A purlin (or historically purline, purloyne, purling, perling) is a longitudinal, horizontal, structural member in a roof.
The nail, as shown in the patent document. The HurriQuake nail was a construction nail designed by Ed Sutt for Bostitch, a division of Stanley Works, and patented in 2004.. The nail was designed primarily to provide more structural integrity for a building, especially against the forces of hurricanes and earthqua
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
Roll roofing is usually restricted to a lightweight mat compared to shingles, as it must be rolled for shipment. Rolls are typically 36 inches (91 cm) by 33 feet (10 m) in size. [citation needed] Due to its light weight compared to shingles, roll roofing is regarded as an inexpensive, temporary material. Its broad width makes it vulnerable to ...
This method eliminates the need for mitre joints, face nailing, and the use of joints on 16-inch (410 mm) or 24-inch (610 mm) centres of conventional framing. For many uses, tongue and groove boards have been rendered obsolete by the introduction of plywood and later composite wood boards, but the method is still used in higher-quality boards.
Treenails and iron nails were most common until the 1780s when copper nails over copper sheathing became more popular. [3] As late as the 1870s, merchant ships used treenails and iron bolts, while higher quality ships used copper and yellow metal bolts and dumps.
A lookout, [1] lookout rafter or roof outlooker [2] is a wooden joist that extends in cantilever out from the exterior wall (or wall plate) of a building, supporting the roof sheathing and providing a nailing surface for the fascia boards. When not exposed it serves to fasten the finish materials of the eaves.
In rural Scandinavia, wood shingles were a common roofing material until the 1950s. [disputed – discuss] Wood shingles are susceptible to fire and cost more than other types of shingle so they are not as common today as in the past. Distinctive shingle patterns exist in various regions created by the size, shape, and application method.
Ad
related to: nail size for roof sheathingebay.com has been visited by 1M+ users in the past month