Search results
Results from the WOW.Com Content Network
Sustainable automotive air conditioning is the subject of a debate – also known as the Cool War – about the next-generation refrigerant in car air conditioning. An advocacy group, The Alliance for CO 2 Solutions , supports the uptake of carbon dioxide (CO 2 ) as a refrigerant in passenger cars, and the chemical industry is developing new ...
The absorption cycle is the one limiting the choice of the refrigerant. The most common refrigerants for absorption systems are ammonia and water. [13] Both are good for combined absorption-compression heat pumps. [14] [15] Ammonia has an exceptionally good solubility in water. This is an important aspect that increases the performance and ...
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
For a typical air conditioning system, this air at state point 1 enters the cooling coil and leaves at about state point 4' after cooling and drying. State point 4' represents the temperature and moisture content of the air that leaves the typical unit, about 45–50 °F (7–10 °C) and 95–98% RH.
Thermodynamic heat pump cycles or refrigeration cycles are the conceptual and mathematical models for heat pump, air conditioning and refrigeration systems. [1] A heat pump is a mechanical system that transmits heat from one location (the "source") at a certain temperature to another location (the "sink" or "heat sink") at a higher temperature. [2]
Adsorption refrigerators are available in the marketplace and are mainly used to produce chilled water from waste heat. Gas adsorption heat pumps are not currently available in the UK, but are just being introduced in Europe as small water or ground source packaged units that provide domestic, low-temperature space heating. [6]
Comparing air and water, air has vastly lower heat capacity per gram and per volume (4000) and less than a tenth the conductivity, but also much lower viscosity (about 200 times lower: 17.4 × 10 −6 Pa·s for air vs 8.94 × 10 −4 Pa·s for water). Continuing the calculation from two paragraphs above, air cooling needs ten times of the ...
Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).