Search results
Results from the WOW.Com Content Network
It had heavier armor, varying from 0.25 in (6.4 mm) to 0.625 in (15.9 mm) thick, and the tank's weight rose to 8.9 short tons (8.1 metric tons). The Cunningham V8 engine had its power boosted to 132 hp (98 kW), giving the T1E2 a slightly higher power-to-weight ratio than its predecessors; despite this, the maximum speed was only 16 mph (26 km/h ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
So 25 mm × .75 = 18.75 mm, or about 19 mm. That is the hatch size in 3/16" scale. Conversion is a fairly simple task once you start measuring in metric and converting according to the scale. There is a simple conversion factor that allows you to determine the approximate size of a model by taking the actual measurements of the full-size ship ...
Accordingly, the barrel shank was enlarged to 28 mm (1.10 in) diameter with 15.88 mm (0.625 in) of threaded area at 12 threads per inch compared to previous Mauser "small shank" bolt-action designs that had 24.9 mm (0.98 in) diameter with 16.38 mm (0.645 in) of threaded area at 12 threads per inch barrel shanks for additional strength.
From 1.0 through 2.95 mm, sizes are defined as follows, where N is an integer from 10 through 29: N · 0.1 mm; N · 0.1 + 0.05 mm; From 3.0 through 13.9 mm, sizes are defined as follows, where N is an integer from 30 through 139: N · 0.1 mm; From 14.0 through 25.0 mm, sizes are defined as follows, where M is an integer from 14 through 25: M ...
For example, AWG 12g is 2.1 mm, but SWG 12g is 2.6 mm. AWG 8g happens to be the same as SWG 10g. AWG 000g is 10.4 mm, but SWG 000g is 9.4 mm. In most discussions of body jewelry, sizes are specified by giving the gauge, usually abbreviated by the suffix "g", the same symbol as used for grams : "12g".
The metric standard used the same thread geometry as the USS standard but differed in that the dimensions and pitch were based on metric units. In 1906, the A.L.A.M developed what would be the SAE thread standard for threaded fasteners based on the USS standard but with a finer thread pitch.
The protective-earth pin is a rectangular cross section 8.0 mm by 4.0 mm, 22.3 mm long and with a centre line 22.2 mm from the line/neutral pin centre line. The dimensions were originally specified in decimal inches with asymmetric tolerances and redefined as minimum and maximum metric dimensions in BS 1363:1984.