Ad
related to: serial device analyzer software
Search results
Results from the WOW.Com Content Network
A typical bus analyzer: this one has an adaptor pod to allow it to interface to Serial ATA devices. A bus analyzer is a type of a protocol analysis tool, used for capturing and analyzing communication data across a specific interface bus, usually embedded in a hardware system. The bus analyzer functionality helps design, test and validation ...
Using a Bus Pirate, a developer can use a serial terminal to interface with a device, via such hardware protocols as SPI, I 2 C and 1-Wire. The Bus Pirate is capable of programming low-end microcontrollers, such as Atmel AVRs and Microchip PICs. Programming using more advanced protocols such as JTAG and SWD is possible, but is discouraged due ...
A serial line analyzer is a device similar to a logic analyzer but specialized for RS-232's voltage levels, connectors, and, where used, clock signals; it collects, stores, and displays the data and control signals, allowing developers to view them in detail.
CANalyzer is an analysis software tool from Vector Informatik GmbH.This development software is primarily used by automotive and electronic control unit suppliers to analyze the data traffic in serial bus systems.
A PC-based OBD analysis tool that converts the OBD-II signals to serial data (USB or serial port) standard to PCs or Macs. The software then decodes the received data to a visual display. Many popular interfaces are based on the ELM327 or STN [41] OBD Interpreter ICs, both of which read all five generic OBD-II protocols. Some adapters now use ...
sigrok is a portable, cross-platform, free open source signal analysis software suite that supports various device types, such as logic analyzers, MSOs, oscilloscopes, multimeters, LCR meters, sound level meters, thermometers, hygrometers, anemometers, light meters, DAQs, data loggers, function generators, spectrum analyzers, power supplies, IEEE-488 (GPIB) interfaces, and more.
Sending data from sub to main may use the opposite clock edge as main to sub. Devices often require extra clock idle time before the first clock or after the last one, or between a command and its response. Some devices have two clocks, one to read data, and another to transmit it into the device. Many of the read clocks run from the chip ...
The software is donateware. The intent of PICKitPlus is to facilitate the programming of any 8-bit PIC microcontroller using the PICkit™ 2 and PICkit™ 3 (ICSP) In-Circuit Debuggers/Programmers. The software extends the life of the existing PICkit2 and PICkit3 hardware devices by allowing them to work with the newer 8-bit PIC microcontrollers.
Ad
related to: serial device analyzer software