Search results
Results from the WOW.Com Content Network
There are many types of parallel ports, but the term has become most closely associated with the printer port or Centronics port found on most personal computers from the 1970s through the 2000s. It was an industry de facto standard for many years, and was finally standardized as IEEE 1284 in the late 1990s, which defined the Enhanced Parallel ...
For example, DB-25 denotes a D-sub with a 25-position shell size and a 25-position contact configuration. The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance ...
The most common usage is the DB25, using TASCAM's pinout (now standardised in AES59 by the Audio Engineering Society [1]). To avoid the possibility of bent pins on fixed equipment, the male connector is generally fitted to the cabling and the female connector to the equipment.
Male pinout of a 25-pin serial port (D-subminiature, DB-25) commonly found on 1980s computers. The following table lists commonly used RS-232 signals (called "circuits" in the specifications) and their pin assignments on the recommended DB-25 connectors [14] (see Serial port pinouts for other commonly used connectors not defined by the standard).
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches (2.54 mm) apart.
The 9-pin DE-9 connector has been used by most IBM-compatible PCs since the Serial/Parallel Adapter option for the PC-AT, where the 9-pin connector allowed a serial and parallel port to fit on the same card. [4] This connector has been standardized for RS-232 as TIA-574.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
T1000-37 Tesuto Breakout box employing commonly used 37 position D-sub connectors that break out to banana jack test points. A four-port serial (RS-232) PCI Express ×1 expansion card with an octopus cable that breaks the card's DC-37 connector into four standard DE-9 connectors Example of a pocket-sized RS-232 breakout box that features switches to reconfigure or patch any or all the active ...