Search results
Results from the WOW.Com Content Network
A wireless microphone, or cordless microphone, is a microphone without a physical cable connecting it directly to the sound recording or amplifying equipment with which it is associated. Also known as a radio microphone , it has a small, battery-powered radio transmitter in the microphone body, which transmits the audio signal from the ...
By connecting one or both wires to a different voltage, the voltage the fan receives will be different from the default 12 V the fan was designed for. Increasing the voltage [ 4 ] over the default 12 V can be achieved by e.g. connecting the −12 V or −5 V power line instead of the ground wire in the fan connector, and by connecting the 5 V ...
As an analogy, the hub of the rotary woofer's fan is somewhat like a helicopter's swashplate which allows a stationary source of reciprocating motion—the voice coil of the subwoofer—to change the angle of the spinning set of blades. Many DIY rotary woofers use a RC helicopter swashplate connected to a modified traditional subwoofer driver ...
Photo: 2.5 mm mono (TS), 3.5 mm mono and stereo (TRS), and 1 ⁄ 4 inch (6.4 mm) stereo (TRS) phone connectors The most common microphone connector in consumer use is the venerable phone connector, in 1 ⁄ 4 inch (6.4 mm), 3.5 mm, and 2.5 mm sizes, and in both mono and stereo configurations.
This connector is used with notebook fans or when connecting the fan to the video card. Dell proprietary This proprietary Dell connector is an expansion of a simple three-pin female IC connector by adding two tabs to the middle of the connector on one side and a lock-tab on the other side. The size and spacing of the pin sockets is identical to ...
Before the bass management system, there is a LFE channel. After the bass management system, there is a subwoofer signal. A common misunderstanding is the belief that the LFE channel is the subwoofer channel. The bass management system may direct bass to one or more subwoofers (if present) from any channel, not just from the LFE channel. Also ...
Loudspeaker enclosures range in size from small "bookshelf" speaker cabinets with 4-inch (10 cm) woofers and small tweeters designed for listening to music with a hi-fi system in a private home to huge, heavy subwoofer enclosures with multiple 18-inch (46 cm) or even 21-inch (53 cm) speakers in huge enclosures which are designed for use in ...
Connecting a low-impedance load such as a loudspeaker (usually 4 to 8 Ω) to a line out will essentially short circuit the output circuit. Such loads are around 1/1000 the impedance a line out is designed to drive, so the line out is usually not designed to source the current that would be drawn by a 4 to 8 ohm load at normal line out signal ...