enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

3. Threaded insert - Wikipedia

   en.wikipedia.org/wiki/Threaded_insert

   TIME-SERT insert. A threaded insert, also known as a threaded bushing, is a fastener element that is inserted into an object to add a threaded hole. [1] They may be used to repair a stripped threaded hole, provide a durable threaded hole in a soft material, place a thread on a material too thin to accept it, mold or cast threads into a work piece thereby eliminating a machining operation, or ...

4. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   Self-tapping screws can be divided into two classes: [3] those that displace material (especially plastic and thin metal sheets) without removing it, known as "thread-forming" self-tapping screws, and self-tappers with sharp cutting surfaces that remove the material as they are inserted, termed "thread-cutting" self-tapping screws.

5. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.

6. Molly (fastener) - Wikipedia

   en.wikipedia.org/wiki/Molly_(fastener)

   The name Molly was formerly trademarked [2] but is now often used in generic reference. Other names used for this same general type of fastener include hollow-wall anchor and hollow-door anchor , sometimes with design variations but always with the same design theme of expansion via deformation as the screw is tightened.

7. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   Hardened set screws often leave a plastic deformation, in the form of a circular or semicircular mark, in the shaft that the screw sets against. This has both pros and cons. On the pro side, such deformation increases the holding power (torque resistance) of the joint, as the screw is essentially "making its own detent" on a small but effective ...