Ads
related to: polishing stones for steelebay.com has been visited by 1M+ users in the past month
toolocity.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
This is followed by washing and then a stage of finer grits (120-220 then 400-600 mesh), before the (optional) use of a pre-polishing compound (1200 grit), a washing cycle with detergent to remove any grit on the stones. The final step is a polishing stage using powdered polish, (such as cerium oxide or tin oxide), water, and often small ...
In metallography and metallurgy, polishing is used to create a flat, defect-free surface for examination of a metal's microstructure under a microscope. Silicon-based polishing pads or a diamond solution can be used in the polishing process. Polishing stainless steel can also increase its sanitary benefits.
For larger polishing jobs, rotten stone mixed with a binder is applied to polishing wheels. It has also been used to polish brass, such as that found on military uniforms, as well as steel and other metals. Plates used in daguerreotypes were polished using rotten stone, the finest abrasive available at the time.
The term is based on the word "whet", which means to sharpen a blade, [2] [3] not on the word "wet". The verb nowadays to describe the process of using a sharpening stone for a knife is simply to sharpen, but the older term to whet is still sometimes used, though so rare in this sense that it is no longer mentioned in, for example, the Oxford Living Dictionaries.
A good polishing reveals what speed the edge was cooled at, from what temperature, and what the carbon content of the steel is. It does this by displaying either predominantly nioi (匂), which is a mix of extremely fine martensite with troostite (another type of tempered steel), or the larger martensite crystals called nie (錵), which look ...
Superfinishing, also known as microfinishing [1] and short-stroke honing, is a metalworking process that improves surface finish and workpiece geometry. This is achieved by removing just the thin amorphous surface layer of fragmented or smeared metal left by the last process with an abrasive stone or tape; this layer is usually about 1 μm in magnitude.
Ads
related to: polishing stones for steelebay.com has been visited by 1M+ users in the past month
toolocity.com has been visited by 10K+ users in the past month